Wash the post filter - step by step guide
Step 1 - Removing the filter
- Ensure the machine is disconnected from the charger before removing the filter. Be careful not to pull the ‘ON ’ trigger.
- To remove the filter, twist anti clockwise to the open position and pull away from the machine.
Step 2 - Washing the filter
- Wash the inside of the filter under cold running water, rotating the filter to ensure all pleats are covered.
- Gently tap the filter against the side of the sink several times to remove any debris.
- Repeat this process 4-5 times until the filter is clean.
Note: The filter may require more frequent washing if vacuuming fine dust or if used mainly in ‘Powerful suction’ mode.
Step 3 - Filter drying
- Place the filter upright and leave to dry completely for a minimum of 24 hours.
- Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave or near a naked flame.
Step 4 - Replacing the filter
- To refit, return the filter to the open position and twist clockwise until it clicks into place.
