Dyson Airblade Tap

Airblade™ technology
in a tap.

Wash and dry
hands at the sink.

See it in action
Images

Click to see:

Features
Costs
Tech spec
Case studies
Range

The Dyson Airblade Tap hand dryer drying hands

No waste water on the floor

With Airblade™ hand drying technology in a tap, hands can be dried at the sink in just 12 seconds. There's no need for users to move to a separate drying area, so no water is dripped on the floor.

Free up your washroom

Other hand drying methods take up valuable wall and floor space. With the Dyson Airblade Tap hand dryer, there's room for extra toilet cubicles and other facilities.

Airblade™ hand drying technology in a tap

Every second, up to 35 litres of air are forced through apertures up to 0.8 mm wide. The result – 690km/h sheets of air that scrape water from hands, drying them hygienically in just 12 seconds.

Dyson Airblade Tap hand dryer costs compared to paper towels and other hand dryers

Saves you money

The Dyson Airblade Tap hand dryer costs an average of just $48 to run for a year. That's up to 69% less than other hand dryers, and up to 97% less than paper towels (see calculations).

Find out more about running costs and use our calculator to see how much you could save by switching to Airblade™ technology.

$48

per year

to run

$157

per year

to run

$1,460

per year

to run

Learn more about costs

Dyson Airblade Tap

Paper towels

Other dryers

4.0 Grams

13.9 Grams

15.6 Grams

0 4 8 12 16

CO₂ produced per dry (grams)

Cuts your carbon footprint

The Dyson Airblade Tap hand dryer has a lower environmental impact than other hand drying methods. It produces 4.0g of CO₂ per dry - up to 74% less than other hand dryers and up to 71% less than paper towels (see calculations).

12 second dry time of a Dyson Airblade Tap hand dryer

Eases washroom congestion

The Dyson Airblade Tap hand dryer takes 12 seconds to dry hands. So users spend less time in the washroom, and busy periods are easier to manage.

Dyson digital motor technology

The Dyson digital motor V4 is one of the world's smallest fully-integrated 1600W motors. It spins 90,000 times a minute, generating the power that makes Airblade™ technology possible.

Dries hands with clean air

Dyson Airblade Tap hand dryers uses a HEPA filter that captures 99.95% of particles the size of bacteria and viruses from the air used to dry hands. So hands are dried with cleaner air, not dirty air.

HEPA filtration

The HEPA filter removes airborne particles from the air. It has a grille to capture larger debris, a fleece layer to capture fluff and fibres, and a pleated HEPA media to capture particles as small as 0.1 microns.

“Our mission is simple. We solve the problems others seem to ignore.”

James Dyson - Chief Engineer

Points to consider before installation

Each Dyson Airblade Tap hand dryer requires the following supply and fit specification.
For more information, please download our installation advice brochure.

Download brochure

Operating environment
Dry, indoor environments only.
Maximum operating elevation 2000m.
Electrical supply
Power range 220-240V, 50Hz 1600W
Water supply
Water pressure between 1-8 bar.
Pipe thread 1/2” BSP.
Clearance distance
Minimum 100mm distance between floor and motor bucket.
AB11 must use metal enclosure as supplied.