Wash the filter step by step guide
Step 1 - Removing the filter
- Ensure the machine is disconnected from the charger before removing the
filter. Be careful not to pull the ‘ON ’ trigger.
- To remove the filter, lift it out of the top of the machine.
Step 2 - Washing the filter
- Wash the filter with cold water only.
- Run water over the outside of the filter until the water runs clear.
- Squeeze and twist with both hands to make sure the excess water is removed.
Note: The filter may require more frequent washing if vacuuming fine dust or if used mainly in ‘Powerful suction’ mode.
Step 3 - Filter drying
- Lay the filter on its side to dry. Leave to dry completely for a minimum of 24 hours.
- Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave or near a naked flame.
Step 4 - Replacing the filter
- To refit, place the dry filter back into the top of the machine. Make sure it is seated properly.
