Removing blockages from the inlet pipe and cyclone shroud

Step 1 - Removing the clear bin from the cyclone

To release the clear bin from the cyclone:

1. Hold the machine by the handle, pull the red lever back and lift upwards to release the cyclone. Continue until the bin base opens fully.
2. Press the red bin release catch located to the rear of the clear bin assembly.
3. Remove the clear bin carefully.

Step 2 - Cleaning the clear bin

• Clean the clear bin with a damp cloth only.
• Do not use detergents, polishes or air fresheners to clean the clear bin.
• Do not put the clear bin in a dishwasher.

Step 3 - Cleaning the cyclone shroud

• Clean the cyclone shroud with the brush on the combination tool to remove lint and dust.
• Do not immerse the whole cyclone unit in water or pour water into the cyclones.

Step 4 - Refit the clear bin

• Ensure the clear bin is completely dry before replacing.
• To replace the clear bin, push the clear bin up and in to the main body of the machine. It will click into place.

Step 5 - Refit the cyclone

• Locate the runners on the cyclone into the slots on the main body.
• Slide the cyclone down fully, until it clicks in place.

Step 6 - Close the bin base

• Close the clear bin base so it clicks into place and is secure.

• Has this resolved the problem?

  
  Yes
• No
• Back