Washing the filter - Dyson V10 Support | dyson.co.nz
Dyson Cyclone V10 Animal

Contact us

Our customer care team is available during the following hours:

  • Mon-Fri 8:30am - 5:00pm EST
  • 0800 397 667
  • Dyson New Zealand, 6 / 99 Carbine Road, Mount Wellington, Auckland, New Zealand,1060
 

Washing the filter

  • Remove the filter unit by twisting anticlockwise to the open position. Gently pull away from the appliance.


  • Wash the inside of the filter unit first; hold it upright under the cold water tap and agitate using a rotating motion.


  • Wash the outside of the filter unit; fill the unit with cold water, place your hand over the open end and shake gently.
  • Repeat washing the inside and outside of the filter unit until the water runs clear.
  • Gently tap the filter unit to remove any excess water and leave to dry with the open end facing up.


Drying the filter

  • Leave the filter unit to dry completely for a minimum of 24 hours.
  • WARNING: Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave, or near a naked flame.


Replacing the filter

  • Check that the filter unit is completely dry.
  • To refit, return the filter unit to the open position and twist clockwise until it clicks into place.

  • Pull the trigger and run the machine for 2 minutes and then check the filter light.